15-Inch 2-Way Powered Loudspeaker, 1,000W Class-D Bi-Amp, 132 dB Peak SPL, 50 Hz–20 kHz Frequency Range, 1.4-Inch Compression Driver, FIR-X Tuning Crossover, D-CONTOUR FOH/Monitor DSP, Onboard 2-Channel Mixer, 50-Degree Monitor Wedge Angle, 35mm Pole Socket, M8 Rigging Threads, 42.6 lb
When the room gets bigger, the music gets fuller, and a 10- or 12-inch box runs out of low end, the Yamaha DBR15 is the powered loudspeaker that keeps up. A 1,000W Class-D bi-amp section drives a custom 15-inch woofer and a 1.4-inch compression driver to a 132 dB peak SPL — enough headroom to carry a full band, a DJ set with real bass, or a packed house of worship without straining. Yamaha built the DBR series on the same DSP, amplifier, and transducer engineering that powers its flagship DXR and DSR professional lines, so the clarity holds together at volume instead of turning to mush when you push it. For anyone deciding between speaker sizes, the DBR15 is the one you reach for when low-frequency punch and output headroom matter more than the last few pounds of portability.
The 15-inch cone rides a 2.5-inch voice coil — a larger motor than the 12- and 10-inch DBR models — and that translates directly to deeper, more authoritative bass that reaches down to 50 Hz. Kick drums hit with weight, bass guitar sits in the pocket, and DJ tracks keep their bottom octave intact, all without a separate subwoofer in rooms where one isn't practical. The 800W of dedicated low-frequency amplification means the woofer has the power to stay clean and dynamic even at full tilt, while a 4-speed cooling fan keeps the Class-D amp stable through long sets. If you've been adding a sub just to get usable low end out of a smaller top, the DBR15 closes that gap in a single cabinet.
Yamaha's FIR-X tuning crossover at 2.1 kHz uses a linear-phase FIR filter to align the woofer and the 1.4-inch compression driver in both time and phase — so vocals stay intelligible, transients stay sharp, and the handoff between low and high frequencies sounds like one source rather than two. On the back panel, D-CONTOUR onboard DSP gives you two purpose-built presets: FOH/MAIN flattens and extends the response for front-of-house mains, while MONITOR retunes the speaker for use as a floor wedge where proximity and feedback resistance matter more than flat extension. One switch adapts the same speaker to two completely different jobs.
The DBR15 carries its own 2-channel mixer, so a small setup can skip the external board entirely. Channel 1 is an XLR/TRS combo jack that takes a microphone or line source; Channel 2 adds a second combo input plus RCA jacks for a phone, media player, or laptop output. An XLR output lets you pass Channel 1 through to a second cabinet or send a CH1+CH2 mix downstream — so a stereo pair, or a main-plus-monitor rig, wires up with nothing more than the speakers themselves. Paired with a digital mixer's main outputs, the DBR15 becomes a clean, powered front-of-house with no amplifier rack to haul.
Despite the 15-inch woofer, the DBR15 weighs just 42.6 pounds — the most portable powered speaker class Yamaha makes — thanks to a rugged molded plastic cabinet, a protective steel grille, and dual ergonomic side handles for a balanced one-person carry. A 35mm pole socket on the bottom drops it straight onto a speaker stand or a subwoofer pole, and three M8 rigging threads (two on the bottom, one on the rear) accept optional brackets or eye-bolts for fixed installation. The 50-degree wedge angle on the symmetrical enclosure means the same speaker you fly as a main can lie down as a stage monitor — one box, every position in the rig.
If you're buying your first real PA, the DBR15 is the speaker that won't leave you wishing for more output six months in — its 132 dB headroom and 15-inch low end cover everything from a solo act with backing tracks to a full band. If you're upgrading from a smaller powered top, you'll immediately hear the difference a larger motor and 1,000 watts make in the bottom end. And if you're comparing models on spec, the numbers tell the story: 50 Hz extension, FIR-X phase alignment, dual DSP voicings, and a portable 42.6-lb cabinet from the engineering team behind Yamaha's flagship touring boxes. Buy the pair, mount them on poles, and you have a complete front-of-house.
| MPN | DBR15 |
|---|---|
| Color | Black |
| On Promo | No |
| UPC / EAN | 86792992396 |
| Brand | Yamaha |
| Product Condition | New |
| Availability | In Stock |
| Speaker Type | 2-Way, Bi-Amp Powered Loudspeaker, Bass-Reflex |
| LF Driver | 15″ Cone, 2.5″ Voice Coil, Ferrite Magnet |
| HF Driver | 1.4″ Diaphragm / 1″ Throat Compression Driver |
| Amplifier | Class-D, Bi-Amp |
| Dynamic Power | 1,000 W (LF 800 W + HF 200 W) |
| Continuous Power | 465 W (LF 400 W + HF 65 W) |
| Max SPL (1m, on-axis) | 132 dB SPL |
| Frequency Range (-10 dB) | 50 Hz – 20 kHz |
| Crossover | 2.1 kHz, FIR-X Tuning (Linear-Phase FIR Filter) |
| Nominal Coverage | 90° H x 60° V |
| DSP Processor | D-CONTOUR (FOH/MAIN, MONITOR, OFF) |
| Inputs | CH1 XLR/TRS Combo; CH2 XLR/TRS Combo + RCA |
| Output | XLR (CH1 Thru or CH1+CH2 Mix) |
| Monitor Wedge Angle | 50° |
| Pole Socket | 35 mm (Bottom) |
| Rigging | M8 Threads (Bottom x2, Rear x1) |
| Cabinet | Plastic, Steel Grille |
| Dimensions (W x H x D) | 17.9″ x 27.6″ x 14.9″ |
| Net Weight | 42.6 lb (19.3 kg) |
| Finish | Black |