Rode Charge Case+ Charging Case for Wireless GO (Gen 3) and Wireless PRO

Rode Charge Case+: Triple the Runtime of Your Wireless Kit Without a Wall Outlet

The Wireless GO (Gen 3) and Wireless PRO already deliver 7 hours of runtime per unit, but a working event day rarely cooperates with one battery cycle. The Charge Case+ solves the runtime problem and the transport problem in a single accessory: an integrated lithium-ion battery delivers two full recharges of the complete system — two transmitters and one receiver — for up to 21 additional hours of recording in the field. Plug one USB-C cable into the case, and every unit inside charges at once. Pull the kit out of a backpack mid-shoot, and the transmitters come back already topped up. Three Wireless GO (Gen 3) units in their own protected slots, fully charged, ready to clip on.

Two Full Recharges, 21 Hours of Extra Runtime, Zero Wall Outlets

The Charge Case+ houses a lithium-ion battery sized to fully recharge the complete Wireless GO (Gen 3) or Wireless PRO system twice. For a creator doing back-to-back weddings, multi-day documentary shoots, or a full-day corporate event with no outlet access, that math is decisive: each unit gives 7 hours on its own battery, the case adds up to 14 hours more through its internal cell, for a combined working day approaching 21 hours of recording per kit. Recharging the case itself over USB-C takes approximately 2 hours from a standard 5V/3A power source.

Simultaneous Data Access — RODE Central Without Unboxing

The Charge Case+ is more than a battery sleeve. It is a powered USB hub for the system. With the case plugged into a Mac or Windows computer, all three units inside become available to RODE Central simultaneously — for exporting the on-board 32-bit float recordings off each transmitter, configuring device settings, and pushing firmware updates. There is no need to remove the units from their protected slots to manage the kit. A wedding videographer can pull the day's audio off both transmitters into a project folder while the case continues charging, hands-free.

Snug, Safe, Secure — Designed for the Backpack and the Glovebox

Each transmitter and the receiver sit in custom-cut slots that prevent the units from shifting, rattling, or scuffing. The zip-around exterior protects the kit against knocks, drops, and ordinary bag-toss abuse. The 98 x 78 x 71 millimeter footprint fits a camera bag pocket, a backpack pouch, or a glovebox without taking the space of a dedicated hard case. The case itself weighs 185 grams empty — light enough to forget it is in the bag.

Cross-Compatible with Wireless GO II — Future-Proof for the Studio

The Charge Case+ slots accept the Wireless GO (Gen 3) and the Wireless PRO directly, and the form factor is also compatible with the Wireless GO II for users who own both generations or who have a Gen 2 kit assigned to a B-camera. A team running mixed-generation hardware can use one charging case for both, and a buyer upgrading from Wireless GO II to Gen 3 over time keeps the case investment intact through the transition.

Who This Is For

The Charge Case+ is for the Wireless GO (Gen 3) or Wireless PRO owner who shoots more than one job a day, travels between shoot locations without outlet access, and does not want to think about whether the transmitter will die during the speech. It is the obvious add-on for wedding videographers, run-and-gun documentary shooters, multi-camera event crews, and any creator whose schedule does not stop for a wall outlet.