Pioneer DJ HC-CA0403 Straight Headphone Cable for HRM-7 HRM-6 HRM-5 3.9 ft

Pioneer DJ HC-CA0403: The Compact Replacement Cord That Revives Your HRM Headphones

The Pioneer DJ HC-CA0403 is a 3.9-foot (1.2-meter) straight replacement cable for the HRM-7, HRM-6, and HRM-5 professional studio monitor headphones. When a short cord frays at the plug or starts cutting out, this factory-length replacement gets a trusted pair of headphones singing again in seconds, with no soldering and no shopping for a new set, just clean sound restored.

A Proprietary 2.5mm Earcup Plug and a 3.5mm Right-Angle Source Connector

Like its longer sibling, the HC-CA0403 pairs a proprietary 2.5-millimeter stereo TRS mini-jack at the HRM earcup with a 3.5-millimeter (1/8-inch) stereo TRS right-angle plug at the source, both finished with gold-plated contacts for corrosion resistance and a stable, low-noise connection. The molded strain-relief ends grip tightly to limit the vibration and signal loss that creep in as a worn cord loosens, and because the cable simply unplugs from the earcup, swapping it takes seconds rather than a trip to the repair bench.

3.9 Feet Sized for Close-In Monitoring and Mobile Rigs

At 3.9 feet, this is the short, manageable cord for working close to the source, whether tracking at a compact desk, monitoring off a portable interface, or plugging into a headphone amp within arm's reach. The tighter length keeps slack off the floor and out of the way, making it the go-to for mobile and cramped setups where the 9.8-foot HC-CA0402 would be more cable than you need.

Who the HC-CA0403 Is For

Producers, engineers, streamers, and students who monitor on the HRM-7, HRM-6, or HRM-5 keep the HC-CA0403 on hand to revive a favorite pair of headphones or to run a shorter, tidier cord at a compact station. If your HRM cable has worn out at the plug, this is the exact factory-length replacement. This listing is for the cable only; the headphones are sold separately.