Hosa CPR-203 Dual RCA to Dual 1/4-Inch TS Stereo Interconnect Cable, 9.9 Feet

Hosa CPR-203: The Stereo Cable That Bridges RCA Gear to 1/4-Inch Inputs

The Hosa CPR-203 solves a specific connection problem that trips up a lot of first-time setups: your source has dual RCA outputs, but your monitors or mixer take 1/4-inch TS plugs. This 9.9-foot stereo interconnect carries left and right line-level audio from a dual-RCA source straight into dual 1/4-inch TS inputs, no adapters stacked on adapters and no signal compromise in between. It is the cable you reach for when a turntable, a CD deck, or any consumer RCA component needs to feed gear built around 1/4-inch jacks.

Oxygen-Free Copper and Nickel-Plated Connectors for a Clean, Reliable Signal

Cheap interconnects cut corners on the conductor and the contact, and you hear it as dropouts, hiss, or a channel that fades after a year of use. The CPR-203 runs oxygen-free copper conductors that keep resistance and signal loss low across the entire 9.9-foot length, so the audio that leaves your source is the audio that arrives at your speakers. The connectors are nickel-plated to resist corrosion and hold a tight, repeatable contact every time you plug in. For the listener who can hear the difference between a quiet noise floor and a noisy one, the conductor and plating are where it starts.

Built to Survive the Plug-and-Unplug Cycle

The point where a cable fails first is almost always the joint between the plug and the wire. The CPR-203 uses molded strain-relief plug bodies — the connector and the cable jacket are formed as one piece, so the internal solder joints are not taking the strain every time you coil the cable or pull it from a jack. That is why this is the cable that stays in the setup instead of getting replaced. The 9.9-foot length gives you room to route cleanly behind a desk or across a room without pulling anything taut.

Who the CPR-203 Is For

For the first-time vinyl owner wiring a turntable into powered studio monitors that only have 1/4-inch and XLR inputs, this is the missing link that makes the chain work. For the home-studio user routing a line-level RCA source into a mixer or interface, it is a clean, no-fuss stereo run. And for anyone who has fought with stacked RCA-to-quarter-inch adapters that buzz and fall out, the CPR-203 replaces the whole stack with one purpose-built cable. Plug it in once and stop thinking about it.