Adam Audio T7V 7-Inch Active Studio Monitor Pair Mixing Bundle with 2 Hosa STX-105M 5-Foot Balanced 1/4-Inch TRS to XLR Interface Cables

Adam Audio T7V Pair: A Complete Stereo Reference for the Home and Project Studio

Mixing decisions are only as trustworthy as what you hear. This bundle puts a matched pair of Adam Audio T7V 7-inch active nearfield monitors on your desk along with the two balanced interface cables that connect them, so you can set up an accurate stereo reference the day it arrives. The T7V carries the U-ART accelerated ribbon tweeter and HPS waveguide from Adam Audio's higher-end lines into an attainable 7-inch monitor — built for the home-studio mixer, the project-studio producer, and the content creator who needs a mix that translates to earbuds, laptops, and car speakers. Two monitors, two cables, one order: a finished monitoring chain, not a pile of parts to source.

What the U-ART Ribbon Tweeter Does for Detail and Long-Session Comfort

The U-ART (Universal Accelerated Ribbon Tweeter) is the T7V's signature. Its low-mass ribbon moves air with a 4:1 velocity transfer that resolves transients — the snap of a snare, the air on a vocal, the decay of a cymbal — and extends response to 25 kHz. Reviewers consistently call out the top end as detailed but non-fatiguing, which matters when you are EQing for hours: a harsh tweeter pushes you to mix dark, and the mix falls apart on other systems. The U-ART lets you trust the high frequencies and make decisions that hold up everywhere.

39 Hz of Bass and a Wide Sweet Spot from a 7-Inch Cabinet

The 7-inch polypropylene woofer reaches down to 39 Hz, low enough to hear kick fundamentals, bass guitar, and synth sub-lines without adding a subwoofer in a small room. Bi-amped Class-D power — 50W to the woofer and 20W to the tweeter, 70W total per monitor — drives the pair to 110 dB peak SPL with serious headroom for nearfield work. The HPS waveguide, carried over from the flagship S-Series, controls high-frequency dispersion so the stereo image stays stable even when you lean out of the exact listening position. One or two people can work at the desk and still hear an honest mix.

Tune the Monitors to Your Room with Rear-Panel Trims

No room is acoustically perfect, and a desk near a wall or in a corner colors the sound. The T7V's rear panel adds high-shelf and low-shelf trims at -2, 0, and +2 dB so you can tame a boomy corner or lift a dull top end to match your space. Each monitor accepts a balanced XLR input (+4 dBu) from an interface or mixer and an unbalanced RCA input (-10 dBV) for consumer sources, and the front-firing bass-reflex port means the monitors work close to a wall without choking the low end.

Two Balanced Hosa STX-105M Cables Make the Connection Clean and Tidy

A monitor is only as quiet as the cable feeding it. This bundle includes two Hosa STX-105M interconnects — 5-foot balanced cables with a stereo 1/4-inch TRS male plug on one end and a 3-pin XLR male on the other. That is exactly the connection most audio interfaces need: a balanced 1/4-inch TRS monitor output on the interface into the balanced XLR input on each T7V. Oxygen-free copper conductors and a spiral shield reject the EMI and RFI that monitors, Wi-Fi routers, and LED lighting throw off, so the signal path stays free of hum and buzz. Nickel-plated plugs grip firmly, and the 5-foot length keeps a desk setup tidy without slack.

How the Pair and the Cables Work Together as One Monitoring Chain

The two T7V monitors give you the left and right of an accurate stereo field; the two STX-105M cables give you the balanced, low-noise path from your interface to each monitor. Together they form the full output side of a home studio: interface monitor outputs to balanced inputs, EQ-trimmed to your room, ready to reference. Nothing about this kit is improvised — the cables are the correct connector type and length for the job, and the monitors are a true matched pair rather than two singles bought separately.

For the First Studio, the Upgrade from Headphones, and the Spec-Driven Buyer

If this is your first set of monitors, you get a complete, correctly wired pair and a top end you can trust without learning a new monitor's quirks. If you are upgrading from headphones or cheaper desktop speakers, the 39 Hz extension and U-ART detail reveal low-end and high-frequency problems your old setup hid. And if you are comparing on specs, the numbers hold up: 70W bi-amped per monitor, 39 Hz to 25 kHz, 110 dB peak SPL per pair, balanced XLR and RCA inputs, and room-trim EQ — in a 7-inch nearfield that shares the sonic family of Adam Audio's commercial-studio lines. Set the pair, run the cables, and start mixing.